Collaboration diagram for Test netcage wake:

Test SimObject for NetCageWakeField wake attenuation.

Creates and registers a NetCageWakeField with the Environment for testing wake current reduction around net-cage structures. The cage is moored: its wake is a velocity deficit relative to a zero source velocity, oriented along the ambient current at the cage, so the waked current is (1 - d) of the ambient current and still water stays still.

Note: Requires Environment SimObject to be initialized first.

Parameters

Name	Width	Description
FullWakeDepth	1	Full wake depth [m]; finite and not negative. Required.
WakeAngleDeg	1	Wake spreading half-angle [degrees]; in (0, 90), else a setup error. Required.
FullWakeDiameter	1	Full wake diameter [m]; finite and positive. Required.
InitialBoundaryLayer	1	Initial boundary layer thickness [m]; finite and not negative. Required.
MaxDeficit	1	Velocity deficit d in the full wake region [0, 1]: the current there is reduced to (1 - d) of the ambient current. A value outside [0, 1] is a setup error. Required.
Position	3	Cage position [x, y, z] in NED frame [m]; the wake depths are measured from z. (Default: 0, 0, 0)
DeficitCutoff	1	Deficit below which the far wake is cut off, sizing the wake's bounding box. Must be > 0, else a setup error. Required.

This SimObject is referred to as TestNetcageWake