FhSim  3.1.0
Marine systems simulation
Loading...
Searching...
No Matches
0160 — Regularised seabed friction: a cable lying on the seabed creeps to its static state over hours (E6a, OC4 line)
ID 0160
Class KNOWN-LIMITATION
Severity 2
Status blocked

Models: — (annotated on the fhsim_environment library group)

Found: 2026-11-18, validation case E6a (fhsim_validation, cases/structures/cable_statics/E6a_oc4_mooring_line_static), review of plan HP wave 1

Decision needed: the owner chooses whether a static result of a cable with a long lying part must be reachable in a short run (a static start, a faster law at rest, or a documented long settle time), or whether E6a keeps its accepted miss for the long-lying rows.

Evidence

include/fhsim_environment/seabed/SeabedContact.h:137-141: the slip force is (μ F_n + α s_u A_s) v / sqrt(|v|² + v_reg²), with v_reg = 0.01 m/s (include/fhsim_environment/seabed/SeabedLaw.h:20). Near rest it acts as a damping of about μ F_n / v_reg. It vanishes at rest, so the static state is the frictionless catenary, but the lying part creeps there slowly.

Case E6a (exact, 1 %, OC4 Phase II mooring line, frictionless elastic catenary with a lying part, sim_time 300 s): spans 780 to 810 m are within 0.2 %. At 700 m (664 kN of line weight on the seabed) the simulated H is about 105 kN against 30 kN, +117 to +249 % by variant. At 740 m H is +7 to +11 %. The review estimates a creep time constant of about 6500 s at 700 m (catenary stiffness about 2 kN/m). H moves only about 0.1 % per 10 s at 300 s, so the 1 % settle check of the runner passes on a state that is not at rest. Not verified by a long run.

The soil law applies to all cable objects with bottom contact (ME InternalCableWithBottomContact.cpp:74, RMCable/Cable.cpp:771). No input sets the friction to zero (Environment.h:182: "The seafloor forces have no options"; marenv SoilState.h:17-18, mu 0.2).

ENV-0147 (stiction) is the opposite effect: a hold at rest would make the frictionless reference wrong.

Effect

A mooring line or trawl warp with a long part on the seabed needs runs of hours to reach its static tension. A shorter run gives a horizontal tension that depends on the start shape, and a settle test on a short window can accept it.

Possible fix

  • A static start: the cable objects start on a catenary with seabed contact (an input of the cable objects, not of this library).
  • Document the settle time in the seabed user doc (time constant μ F_n / (v_reg k)).
  • Leave the law and keep the E6a accepted miss.

Test that would prove it

E6a rows 700 m and 740 m pass 1 % in a run of the case's sim_time (fhsim_validation, runner filter E6a*, gate class).

Risk

A change of the law at low slip speed moves every result with seabed contact (anchors, trawl gear, moorings) and interacts with ENV-0147.